Видео

8/9/24 1218 hrs. You are the only individual that clearly explained and showed the process. This was out of approximately fifteen to twenty videos. Thanks!

😊

Good job

Before you start, disconect the battery and you have the ignition on .

Cheers buddy 👍

hello, nice video! Do you need to set them to fitting position from the console or that's only for the rear brake pads? thank you

Thanks - very good review.

My brake pedal is hard what could be the problem

Hi quick question I have a jcb 525 the engine light pops up now its saying p0222 would that be the accelerator sensor

Wtf... I've had my Zaf for nearly 6 months and didn't realise that was a storage compartment 😂

Very helpful. Thanks.

I’m just about to do this job and on the one hand, I like the video but, and it’s a big but! You didn’t included the difficult stuff. Having read the manual, I know the front bumper and front grill has to come off. It’s a real pain in the neck. So the only way this could have been improved is by including this process. The bulb change is fairly straight forward. If you get the opportunity to, I will video it. It’s likely to get a high viewership.

Where is this located on a 2009 mk7 transit

Does the drain plug need a new gasket?

Thank you! easy when you know how

Anyone able to tell me the part number please? Thank you

Which connector is the antenna, green or black please ?

thanks a lot, you save my day

Thank you - very helpful (most important part is the workshop menu) Is there only one brake pad sensor that needs replacing?

thanks

Like

I'm a bit thick but is it fitted from 11 to 12 o clock if looking from front of headlight or from back? Thanks in advance.

Thanks allway handy !

А что снял не центральную черную часть?

Useless video. Where the hell is the exact location?

One handed RUclipsrs

Sorry this a stupid question I know but the other bulb is the indicator bulb is that right ?? I just do the same as you have done but change the other bulb for indicators right?? Thanks for help

Great Video 👍👍👍👍

That's just how to remove the arm not the bush itself

شكرا thank you

Another idiot with copper grease everywhere. Wtf is wrong with you home grown mechanics???

Hi. How do I get the air pocket out of the heater core after refilling antifreeze?Thanks

Great video, thank you.

It would help if you talked and said what tools you used…

It’s amazing how after you removed the headliner the curtain just replaced itself off camera!

Thank for my 19 plate VW sharan

Is it really this easy, my mechanic said to tell take two hours

Thank for taking your time to show us how to do it. Sure i would of broken something otherwise!

Brand new yea?

Terrible video..sorry

Omg.. Never only use a car lift jack.. I had a 2 ton Clarke one and it started dropping slowly by itself! Be careful

What size wrench to loosen the tensioner

How do you depressurize the fuel lines so you don’t get sprayed with diesel? Thanks!

Hi, what did you use to refit the new bush?

Paldies par informaciju

Very helpful - thanks mate

That filter is for gas or diesel??

Great video - thank you! Okay, my 2009 Passat CC 2.0TDI fuel flap is getting harder and harder to open using the flip switch on the inside of the driver's door. I suspect that electro-mechanical actuator you show is on the way out! I got the part number from your video: ZSB 3C8 810 773A - is that right? I might have to go buy one and put it in!

Swapping carbon for basic. Bad move.

Your video is very helpful for me. So I do it by myself according to your video. But